INSTALLATION & WIRING FAQ

What tools do I need to install access control hardware?

What are the minimum clearances required for keypad installation?

Can access control readers be installed outdoors?

How do I mount products on brick or concrete?

What gauge wire should I use for power distribution?

How should I handle power supply wiring for multiple readers?

What is the maximum cable run for RS-485 communication?

How do I prevent electrical noise and interference?

Do I need a separate power supply for electric locks?

How far apart should multiple readers be installed?

What's the correct way to wire a BRB relay module to a door strike?

Can I daisy-chain keypads on the same data line?

How do I test if a reader is receiving power?

What's the proper way to wire a multi-door controller?

Do I need a battery backup for the power supply?

How should I connect an access controller to a network?

What safety devices should I install in the wiring system?

Reader isn't responding—what should I check first?

Cards are being read intermittently—what causes this?

Electric lock won't release reliably. Why?

How do I diagnose voltage drop issues in long cable runs?

How should I label and document my installation?

What safety precautions should I take during installation?

Should I use conduit for cable runs?

What maintenance should be performed after installation?